Minelab E-Trac Bedienerhandbuch PDF herunterladen (Seite 26)

48

49

Auto Accept Mode

When a target is detected in Auto Accept

Mode, the Discrimination Pattern will be

automatically modied to accept the FE-CO

coordinates of that target.

To Auto Accept the target:

1 Place the target on the ground

2 Press the Right Shift button until the Auto

Accept Edit Mode is selected

3 Swing the coil several times over the

desired target until the detector accepts

it by clearing an area in the Smartnd

Window. If you have more than one target,

repeat the procedure for each one

4 Press the Detect button (or QuickMask

button if you wish to load the pattern into

QuickMask) once you have nished editing

5 Answer ‘Yes’ to the dialogue box to return

to the Pattern/Digital (or QuickMask) Screen

with your new Discrimination Pattern

loaded into Smartnd

Discrimination Menu

E-Trac needs to detect the target consistently

to accept it into the Smartnd Disc. Pattern.

Creating a Discrimination Pattern

using Auto Accept:

Fill in the Smartnd Window:

Press the Left Shift button until the ‘All

Pattern’ Edit Frame is selected. Press the

Accept/Reject button twice to reject the

entire Discrimination Pattern. This lls in the

Smartnd Window, rejecting all targets

and preparing the Window for learning a

new target.

Change the size of the cursor:

Press the Left Shift button to change the

Edit Frame size (Small, Medium, Large or

All Pattern).

CAUTION: Pressing the Menu Button

while in Edit will take you back to the

Discrimination Menu and all changes

made in Edit will be lost.

Auto Latch Mode

The Auto Latch Mode automatically selects

the FE-CO coordinates of a detected target.

This allows you to either accept or reject the

target from the Discrimination Pattern using

the Accept/Reject button.

To Auto Latch the target:

1 Place the target on the ground

2 Press the Right Shift button until the Auto

Latch Edit Mode is selected

3 Swing the coil several times over the

desired target until the detector conrms

the FE-CO coordinates

4 Press the Accept/Reject button once to

reject those coordinates from the Smartnd

Discrimination Pattern, press twice to

accept. If you have more than one target,

repeat the procedure for each one

5 Press the Detect button (or QuickMask

button if you wish to load the pattern into

QuickMask) once you have nished editing

6 Answer ‘Yes’ to the dialogue to return to

the Pattern/Digital (or QuickMask) Screen

with your new Discrimination Pattern

loaded into Smartnd

Tip: Changing the Trash Density setting (pp.

72–3) from High to Low can stabilise the

FE-CO coordinates of a detected target while

using any ‘Auto’ Edit Modes.

Creating a Discrimination Pattern

using Auto Latch:

Clear the Smartnd Window:

Press the Left Shift button until the ‘All

Pattern’ Edit Frame is selected. Press the

Accept/Reject button once to accept the

entire Discrimination Pattern. This clears the

Smartnd Window, accepting all targets

and preparing the window for learning a

new target.

Change the size of the Edit Frame:

Press the Left Shift button to change the

Edit Frame size (Small, Medium, Large or All

Pattern). A Large frame will accept a larger

area of the Discrimination Pattern as a target

is detected. A Small frame will accept a

smaller area of the Discrimination Pattern,

but slightly altered or damaged targets may

be ignored.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare