Minelab E-Trac Bedienerhandbuch PDF herunterladen (Seite 34)

64

65

Audio Menu

Sounds

Range: Conduct or Ferrous

Factory Preset: Conduct

The Sounds setting allows you to set

the detector to emit a distinct audio

response based on either a target’s ferrous

characteristics or its conductive properties. To

test your selection it is necessary to move the

coil across one or more targets with dierent

conductive and ferrous characteristics.

Note: Even though you can still adjust the

Sounds when the No. of Tones is set to 1,

it will not have any eect on the target

audio response.

Conduct

When Conduct is selected, audio tones are

emitted according to the target’s conductivity

(the horizontal axis of the Smartnd Window,

or the second number in the Digital Screen).

A high pitched signal denotes a large, highly

conductive object with Target Crosshair

displayed near the right of the Smartnd

Window (or near a CO number of 50).

A low pitched signal denotes a small object

with low conductivity; the Target Crosshair

is displayed near the left of the Smartnd

Window (or near a CO number of 1).

Tip: Conduct is often preferred by coin hunters,

as desirable targets such as gold, copper and

silver coins will give a high tone signal response,

compared to low conductive junk targets such

as foil and pull tabs.

Tone ID

The Tone ID sub-menu allows you to dene

how the tone of the audio varies when

dierent target characteristics are detected.

This can be a very useful feature in identifying

targets close to each other.

Number (No.) of Tones

Range: 1, 2, 4 or Multi

Factory Preset: Multi

You may select how many dierent tonal

responses there are while detecting.

These are:

– 1; all sound is monotone,

– 2; all sound is duo tone i.e. low and high,

– 4; four dierent tones ranging from low

to high,

– Multi; multiple tonal responses to dierent

target signals.

The Factory Preset number of Tones is set

to ‘Multi’, giving multiple tonal responses to

dierent targets.

To change the Number of Tones:

1 Press the Menu button

2 Scroll across to Audio (using the Right or

Left Navigation button)

3 Scroll down to Tone ID (using the Down

Navigation button)

4 Press either the Left or Right Navigation

button to enter the Tone ID sub-menu

5 Scroll down to No. of Tones

6 Press either the Left or Right Navigation

button to change the No. of Tones

7 Press the Detect button to exit the Menu

and resume detecting

Conductivity

Conductivity

High Pitch

High Pitch

Low Pitch

Low Pitch

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare