Minelab EXPLORER II Wartungshandbuch PDF herunterladen (Seite 20)

THE MINELAB EXPLORER II

ASSEMBLY

www.minelab.com

Connecting the shaft assembly to the handle assembly

Figure 2.6–2.9

NOTE Shaft orientation: camlock is on lower side of upper

shaft.

To connect the shaft assembly to the handle assembly:

STEP 1 (Figure 2.6) Release the control box camlock lever to the

open position.

STEP 2 (Figure 2.6) Align the connections and push the coil cable

connector into the socket underneath the handle

assembly control box. Ensure the connector’s threaded

bracelet is firmly secured.

STEP 3 (Figure 2.7) To prevent the coil cable from ‘bunching’,

extend the lower shaft from the upper shaft by

approximately 15cm (6 inches).

STEP 4 (Figure 2.8) Making sure that the control box camlock

lever is in the released position, push the upper shaft

firmly into the control box until you feel it has reached the

back of the control box.

CONNECTING THE SHAFT ASSEMBLY

Figure 2.6 Attaching coil cable to control box

Figure 2.7 Preventing the coil cable ‘bunching’

P0597-A

P0614-A

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 111 112

Keine Kommentare

Minelab EXPLORER II Wartungshandbuch Seite 20