Minelab EXPLORER II Wartungshandbuch PDF herunterladen (Seite 23)

THE MINELAB EXPLORER II

ASSEMBLY

Figure 2.11 Fitting buckle to armrest strap

Figure 2.12 Fitting armrest strap to armrest

Figure 2.13 Tightening armrest strap

Fitting the armrest strap

Figure 2.11–2.13

To fit and adjust the armrest strap:

STEP 1 (Figure 2.11) Thread the strap through the buckle

openings as illustrated.

STEP 2 (Figure 2.12) Clip both buckles into the openings at each

outer side of the armrest.

STEP 3 Test by sliding your arm underneath the strap and resting

your forearm on the armrest (which should be adjusted to

a comfortable setting).

STEP 4 (Figure 2.13) Loosen strap by tilting the edge of the

buckle out to release it from the armrest. Undo the velcro

and pull the buckle outwards (towards yourself). Clip the

buckle back into place and tighten the strap by pulling up

(in the direction of the top arrow in Figure 2.13).

The armrest should now be adjusted to your satisfaction. Next

time you use your detector, all you will need to do is click the

buckle back into the armrest.

THE HANDLE ASSEMBLY

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 111 112

Keine Kommentare

Minelab EXPLORER II Wartungshandbuch Seite 23