Minelab F3 Wartungshandbuch PDF herunterladen (Seite 30)

F3 INSTRUCTOR NOTES

Minelab Countermine Division Safety Through Excellence

o Ensure batteries are removed before packing

 The Skidplate is designed to protect the Coil and may require

replacement after long periods of use. To replace the Skidplate:

o Use fingers to lever old Skidplate from coil

o Apply even firm pressure around replacement Skidplate and push

onto Coil

P0654-A

F3 Trouble Shooting

 There are a number of actions that an operator can carry out when trying

to fix a possible fault. By conducting fault finding procedures it may prevent the

detector being reported as faulty and thereby result in the continued use of the

equipment. Typical problems and possible solutions are described as follows:

Problem Recommended Procedure

F3 will not switch on

1. Check Batteries have been inserted correctly into

the Battery Pack, or

2. Replace Batteries, or

3. Remove Battery Pack and reconnect ensuring

Battery Pack Lever is locked into position, or

4. Exchange Battery Packs (if this solves the

problem, the original Battery Pack may be faulty)

After switching On there is

a very loud noise

1. Ensure Lower Shaft is extended at least 10cm

beyond the Middle Shaft, or

2. Conduct Audio Reset

After switching On the

Threshold Tone varies in

pitch and volume though

the Coil is stationary

1. Conduct Noise Cancel

Twenty

Eight

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Minelab F3 Wartungshandbuch Seite 30