Minelab F3 Wartungshandbuch PDF herunterladen (Seite 17)

F3 Field Service Manual

Page 17

3.4 Coil. Figure 14 illustrates the major parts involved in removing and replacing the

coil.

3004-0003 COIL KIT SVC F3

3004-0038 KIT SVC COIL RETAINER, contains pt 1 & 3

1 2004-0037 RETAINER COIL BLACK F3

2 2021-0054 COIL F3

3 4005-0039 BLOCK FRICTION COIL F3

4 8009-0007 RETAINER PLUG F3

5 4308-0012 PIN COIL CABLE

Figure 14: Coil

a. To remove the coil:

● Retract the shafts and remove the battery pack.

● Remove the electronics pack as described in Section 3.3.a. However, there is no

need to remove the electronics pack from the upper shaft.

● Remove the coil plug retainer, if fitted, from around the coil plug. (Figure 15)

● Allow the coil cable to retract into the shafts.

Figure 15: Removing Coil Plug Retainer

● Maintaining firm downward pressure on the 6.5mm screwdriver, carefully lever the

coil retainer cover off the coil top and remove it. (Figure 16)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Keine Kommentare

Minelab F3 Wartungshandbuch Seite 17