Minelab F3 Wartungshandbuch PDF herunterladen (Seite 25)

F3 Field Service Manual

Page 25

b. To assemble the handle:

● Position the right handle half onto the upper shaft.

● Lay the wiring loom into the cable channels and ensure the wiring loom plug exits the

top of the handle in front of the upper screw boss. (Figure 31)

Figure 31: Right Handle with Wiring Loom Correctly Positioned

● Ensure the lower portion of the wiring loom cable sits under the rear handle screw

boss and cannot be snagged by the bolts once the handle is assembled.

● Ensure the on/off switch slider is correctly positioned.

● Place the nut (Part 4) which secures the speaker pod assembly to the handle into the

recess near the top of the handle. (Figure 32)

NOTE

Ensure the nut remains in place during the rest of the assembly procedure; otherwise it will

not be possible to secure the speaker pod onto the handle.

Figure 32: Nut (Part 4) Correctly Positioned in Handle Recess

● Fit the earset dustcap into the recess in the handle just forward of the earset plug.

(Figure 33)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Keine Kommentare

Minelab F3 Wartungshandbuch Seite 25